8/10/2023 0 Comments Ironfell reboot![]() Note: Please observe all AWS Safety & Health Guidelines when using Muggy Weld products. After the part completely cooled, we used a sanding disc to remove the residual flux, but hot water and a wire brush or a wire wheel are just as effective. ![]() We covered the work area to keep the heat in and wind off while cooling (to eliminate cracking). Fortunately, SSF-6 easily bonds mild steel to cast iron, so the hole was repaired with only 1/2 stick of SSF-6, and the cast iron exhaust manifold was ready to reinstall within minutes. Old cast iron can be brittle, and while grinding the backside of the crack, a chunk of cast iron fell out. If you run into an area in which the silver solder is not sticking, stop and re-clean the area to ensure no grinder residue is impeding the bond. Each time you deposit more SSF-6, be sure to flow it flat into the base metal before applying more rod. Once the cast iron begins to turn dull red, apply the SSF-6 flux and rod to the crack. This action provides for better bonding of the filler rod, and allows for more even cooling across the cast iron exhaust manifold. Muggy Weld utilized SSF-6 Silver Solder and a MAPP gas torch (later replaced by an oxyacetylene when the MAPP gas ran out) to braze the cast iron manifold.įirst, bevel the crack and clean the cast iron until it is shiny, then preheat the base metal to remove any moisture from the cast iron. Originally, the cast iron manifold was merely cracked, but the crack quickly turned into a hole as they attempted to make the repair. ![]() With the new alliance system you can band together with your friends to take over the world(Mwahaha). It includes a wide variety of units which range from dangerous (but expensive) dinosaurs to harmless( but cute ponies). Resurrection Autobody and Paint in Olympia, WA, contacted Muggy Weld with a cast iron 1963 Cadillac DeVille exhaust manifold in need of repair. Ironfell is a MMORTS game developed by David Colquhoun. Cast Iron Exhaust Manifold Brazing Demonstration:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |